ADWA AD12 pH

Description

Adwa AD12 is the most advanced microprocessor based IP67 Waterproof pH/Temp pocket testers in the market.

Fast, stable and precise, these testers are for users that require the greatest accuracy.

Simple user-replaceable pH/Temp probe: just unscrew the plastic ring on the top of the electrode and replace it with a new one!

2 rows display LCD (reads both pH and temperature measurements) and built-in HOLD function that freezes the display for easy and accurate recording.

Other features such as stability indicator, automatic calibration and automatic temperature compensation make these waterproof pocket testers a must-have in a variety of industries.

The modular design allows to replace the electrode in a fast and simple way.
Comes with pH Buffer 4.01 and 7.01

Range pH-2.0 to 16.0 pH
RangeTemperature-5.0 to 60.0°C / 23.0 to 140.0°F
Resolution pH ±0.01 pH
Resolution Temperature 0.1°C / 0.1°F
Accuracy pH ±0.01 pH
Accuracy Temperature±0.5°C / ±1°F pH
Calibration manual at 2 points with 1 set of memorized buffers (pH 4.01 / 7.01)
Temperature Compensation automatic
Battery Type / Life 4 x 1.5V with BEPS / approx. 300 hours of continuous use
Auto-off after 8 minutes of non-use Environment -5 to 60°C (23 to 140°F)

General problems, solutions

make sure the batteries are inserted correctly (if it doesn't turn on)
if the instrument cannot be calibrated, the error can also be caused by an air bubble trapped between the probes, which can be removed by moving the probe ("knocking")
a common problem is that the Dutchman that clamps the probe is not tightened enough, thus the seal is not suitable and the instrument may get wet, which leads to loss of warranty
the silicone protective cap (which contains the storage fluid) can be used for storage (not the gray plastic)

ATTENTION!

Never immerse probe in high concentration acid or alkaline (undiluted pH minus liquid)!

Never immerse probe in hot liquids, because this may damage the probe.

Air bubble in probe does not cause any problems, because holding the instrument during measurement will cause the bubble to rise up, and stay away from the sensor.

Related products

ADWA pH measuringprobe (for AD11 / AD12)

The information herein is provided by the manufacturer.
Manufacturers can change product information at any time, without prior notice.
We are not liable for any changes.
All pictures shown are for illustration purpose only. The product may be different in reality.
Our sets may vary due to current stock availabilities. If any changes occur, customers will be informed in time.